yusufyaacub/panca-4dimensi: CARA BAIKI PRINTER CANON PIXMA MP248 Night Diamond Bloody Red - Link Select Max

Thursday, August 2, 2012

CARA BAIKI PRINTER CANON PIXMA MP248


salam sahabat buat sekalian~


tadi printer aku ada sikit stuck. time nak potostat, dia keluar separuh je. lepas on off pon tak ok jugak. so, aku cari solution kat youtube. mula2 aku google dulu error code yang selalu ada pada printer model ni.

P02 (Carriage error)
- Make sure no foreign material stuck to the print head railway.
- Clean and check the print head encoder strip cable (timing slit film or encoder strip is a white line on the back of the box set of ink lines may be missing or mess up the ink.

P03 (Line feed error):
- an error in transmission line entering the line feed (LF) is a signal telling the printer to move to another line or a whole new line that would not otherwise have reached the end of the line.
- Check wire print head position (timing slit disk film) on the side of the machine.
- Check PCB logic board.

P05 (ASF sensor error):
- sensor for paper feed error.  
-Try to replace the following:
     -ASF / PE sensor unit.
     -Drive unit.
     -PCB logic board.

P06 (Internal temperature error):
- caused by abnormal heat inside the printer.

P07 (Ink absorber full):
- the Ink Wastepad (sponge) inside the printer is full
- Replace the wastepad inside the printer or install  waste ink bin outside the printer
then Reset counter protection.

P08 (Print head temperature rise error):
- caused by thermal print head temperature exceeds a threshold.
- Replace the new cartridge print head and / or change a new logic board.

P09 (EEPROM error):
- caused by corrupted or defective EEPROM chips of the printer.
- Replace the logic board.

P15 (USB VBUS over current):
- caused by too much current, try removing the USB cable and then plugin again, if solve the error, try to replace with a new USB cable. If the error still exist replace the logic board.

P20 (Other hardware error):
- The failure of other hardware.
- Try to replace the logic board.

P22 (Scanner error):
- a scanner malfunction.
try to change the scanner unit or change a the logic board.

E13 or E16: Ink has run out:
- Pressing the Stop / Reset button for 5 to 8 seconds until the led screen display number 1.

E04, E05, E14 or E15:
- Cartridge may not be installed properly
- Reinstall the ink cartridge.


tadi aku punya error adalah yang P02. kemungkinan ada kabel2 yang tak terletak elok kat dalam tu. bila aku check, memang betul. wayar tiub kaler tu tercabut dari celah cartridge tu dan stuck dekat belakang. aku tengaok kat youtube untuk settlekan. dan terjumpa lain2 solution yang korang boleh buat kalau terjadi lagi macamni atau error2 yang lain.

ERROR CODE P02 STEP 1-2


ERROR CODE P07


ERROR CODE E03


ERROR CODE E04


ERROR CODE E05 STEP 1-3


ERROR CODE E13


ERROR CODE E15


ERROR CODE E16


CARA HILANGKAN ANGIN PADA TIUB PRINTER


CARA PASANG INK TANK (CISS)


ok, itu saja yang sempat aku jumpa. harap membantu. :)

simpul simpulan bahasa sanskrit: jimat duit.....
Comments
0 Comments

0 comments:

Post a Comment

terima kasih sudi komen.. sudikan diri untuk follow saya dan tinggalkan link blog anda di sini. (^__^)v